Digisol DG-FS4528P, Management Manual

Page: 153 / 973

C
HAPTER
6 | Sampling Traffic Flows
Configuring sFlow Port Parameters
– 153 –
W
EB
I
NTERFACE
To globally enable flow sampling:
1. Click sFlow, Configuration.
2. Set the global status for flow sampling, the ports or port groups to be
sampled, and the sampling rate.
3. Click Apply
Figure 47: Configuring Global Settings for sFlow
C
ONFIGURING S
F
LOW
P
ORT
P
ARAMETERS
Use the sFlow > Port Configuration page to set the destination parameters
for the sampled data, payload parameters, and sampling interval.
CLI R
EFERENCES
"Flow Sampling Commands" on page 535
P
ARAMETERS
These parameters are displayed:
Port – Choose the port to configure. (Range: 1-28; Default: 1)
Receiver Owner
4
– The name of the receiver. (Range: 1-256
characters; Default: None)
Receiver IP Address 4 – IP address of the sFlow Collector.
4. Sampling must be disabled by setting the time out to 0 before configuring these fields.