OpenLogger™ Acrylic Case Assembly Manual
Copyright Digilent, Inc. All rights reserved.
Other product and company names mentioned may be trademarks of their respective owners.
Page
7
of
12
Step 3
Place
Layer B
on top of
Layer A
with the same orientation as shown in Figure 8, making sure notches are
appropriately aligned. Note: to help differentiate the middle layers, Layer B is slightly thinner than Layer C and has
a larger open gap. Once Step 3 is completed, set it aside retaining orientation. Do not pick it up off the table. This
part of the assembly will be integrated in Step 5.
Figure 8:Completed Step 3 (Layer B)
Step 4
Have
Layer D
oriented as shown in Figure 9. Set the OpenLogger face-up on top of Layer D as shown in Figure 10.
Then, place
Layer C
around the OpenLogger as shown in Figure 11 noting correct orientation mentioned in Figure 3
with notches in top right corner. The outer edge of the OpenLogger should sit flush with the edge of Layer C.
Figure 9:Layer D Orientation
