![DigiDesign Control 24 Manual Download Page 99](http://html.mh-extra.com/html/digidesign/control-24/control-24_manual_2497142099.webp)
Chapter 11: Recording
89
To make the same output assignment to all
channels simultaneously:
■
Press APPLY TO ALL CHANNELS or
OPT(ALT)/ALL while assigning an output to a
track.
To make the same output assignment to selected
channels only:
■
Press APPLY TO ALL SELECTED CHANNELS or
OPT(ALT)/ALL+SHIFT/ADD while assigning an
output to a track.
To add or remove multiple output assignments:
■
Press CTL/CLUTCH while assigning or dese-
lecting an output to a track.
To temporarily display output assignment:
■
Press OUTPUT.
Assigning MIDI Outputs
You can view and assign channel outputs for
MIDI tracks on Control|24. You can also assign
multiple MIDI channels to a single track.
To assign MIDI outputs from Control|24:
1
Press OUTPUT.
2
Turn the data encoder knob on the track to se-
lect the MIDI device and channel.
3
Press the flashing switch directly below the
data encoder knob to confirm your decision. (If
assigning multiple MIDI channels, perform
steps 2 and 3 while pressing SHIFT/ADD.)
4
When MIDI output assignment is completed,
press the Master ASSIGN switch to confirm and
exit Assign mode.
To assign multiple outputs:
■
While pressing CTL/CLUTCH, while assign-
ing an output to a track.
TrackInput Monitoring
TrackInput monitoring lets you toggle individ-
ual audio tracks between Auto Input and Input
Only monitoring modes at any time, including
during playback or recording.
This feature also makes it possible to toggle a
track between Auto Input and Input Only mon-
itoring mode regardless of whether or not the
track is record enabled.
To toggle the monitoring mode of audio tracks:
1
Hold the CTL/CLUTCH switch and press the
MONITOR/Ø (Monitor/Phase) switch. The
switch flashes to indicate Control|24 is in “Se-
lect Input Monitoring” mode.
2
Do one of the following:
• To toggle individual tracks, press the
SWITCH ACTIVE switch on each channel
you want to toggle.
• To toggle all tracks in the session, hold the
OPT(ALT) ALL switch and press the MONI-
TOR/Ø switch.
• To toggle all selected tracks in the session,
hold the SHIFT/ADD + OPT(ALT)ALL
switches and press the MONITOR/Ø
switch.
Summary of Contents for Control 24
