DigiDesign Control 24, Manual

Page: 147 / 159

Appendix B: Utility Functions 137
Cycle Test Mode
Cycle test mode places the faders on Control|24
in a test mode where the faders cycle, lock-step,
from the bottom of the fader throw to the top in
a continuos cycle. The speed at which the faders
cycle is determined by adjusting the scrub/shut-
tle wheel.
When “Cycl” fader test mode is engaged:
• The encoder switch LED located below the
scribble strip which shows “Cycl” will light
solid indicating that this is the chosen test
mode.
• All other display test menu items shown on
the scribble strips as well as their associated
flashing encoder switch LEDs, will remain vis-
ible in this test mode.
• The scribble strip displays will toggle back and
forth between the cycle values, which allows
you to select another display test mode with-
out the need to first “Exit” this mode.
• The fader position value will be shown in
these scribble strips and will be updated in
real-time as the faders “cycle.” Values will
range from off (value of “0000”) to full-on
(value of “1023”).
• Rotate the scrub/shuttle wheel to adjust the
cycle speed that the faders use. Turning the
wheel to the left decreases the speed while ro-
tating the wheel to the right increases the
speed.
• Press the flashing encoder switch located be-
low the scribble strip showing another test
mode to simultaneously disengage the fader
cycle test mode and enter the newly selected
mode. The encoder switch LED for the new
choice will light solid while the other choices
flash.
• When finished, press EXIT.
Sine Test Mode
Sine test mode places the faders on Control|24
in a test mode where the faders cycle, in a sine
wave shape, from the bottom of the fader throw
to the top. The speed at which the faders cycle is
determined by adjusting the scrub/shuttle
wheel.
When “Sine” Fader Test Mode is Engaged:
• The encoder switch LED located below the
scribble strip which shows “Sine” will light
solid indicating that this is the chosen test
mode.
• All other display test menu items shown on
the scribble strips as well as their associated
flashing encoder switch LEDs, will remain vis-
ible in this test mode. The scribble strip dis-
plays will toggle back and forth between the
sine cycle values, to allow you to select an-
other display test mode without the need to
first “Exit” this mode.
• The fader position value will be shown in
these scribble strips and will be updated in
real-time as the faders cycle in sine mode. Val-
ues will range from off (value of “0000”) to
full-on (value of “1023”).
• Rotate the scrub/shuttle wheel to adjust the
cycle speed that the faders use. Turning the
wheel to the left decreases the speed while ro-
tating the wheel to the right increases the
speed.
• Press EXIT, or press the flashing encoder
switch located below the scribble strip show-
ing another test mode to simultaneously dis-
engage the fader sine test mode and enter the
newly selected mode. The encoder switch LED
for the new choice will light solid while the
other choices flash.