Operation
5
3. Software Operation
3.1. Communication
After successfully log in, a window will pop out if failed to communicate with controller. Click
Confirm to start setting, or click Cancel to enter into DEMO mode.
Your control PC can establish connection with controller via serial port or network.
Default connection is UDP communication. TCP not support by this model at current
stage.
3.1.1. Device Communication
3.1.1.1. Network Communication
For Network connection, you have to ensure your control PC IP and controller IP within same LAN
network.
Follow below steps to configure
1. Navigate to Setup, and Click
「
Communication
」
to enter into setting page.
2. Select Network Setting, input IP address and click OK.
