Digi XBee-PRO XSC RS-232, Product Manual, Page: 8 / 23

XBee ‐ PRO® XSC RS ‐ 232/RS ‐ 485/USB RF Modem ‐ Product Manual
© 2013 Digi International, Inc. 8
Figure 1 ‐ 05. Front View (USB)
1-05a. USB Port
Type B USB port
1-05b. Power Connector
7-30 VDC power connector
1-05c. Reset Button
The Reset Switch is used to reset (re-boot) the XBee-PRO XSC RF
Modem. This switch only applies when using the configuration tabs of
Digi's X-CTU Software.
Figure 1 ‐ 06. Back View (USB)
1-06a. RSSI LEDs
Not applicable to XBee-PRO XSC RF Modem.
1-06b. I/O & Power LEDs
LEDs indicate RF modem activity as follows:
Yellow (top LED) = Serial Data Out (to host)
Green (middle) = Serial Data In (from host)
Red (bottom) = Power/TX Indicator (Red light is on when powered,
off briefly during RF transmission)
1-06c. Commissioning Push Button
Not applicable to XBee-PRO XSC RF Modem.
1-06d. Antenna Port
Port is a 50 Ω RF signal connector for connecting to an external
antenna. The connector type is RPSMA (Reverse Polarity SMA)
female. The connector has threads on the outside of a barrel and a
male center conductor