Digi XBee 3 Cellular LTE-M, User Manual, Page: 240 / 331

AT commands Remote Manager commands
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide 240
Bit Description
2
TCP data estimated transfer counters.
Set bit 2 to enable reporting of data counters for TCP traffic.
The data reported is application data and does not include the overhead of the
protocol. Data not counted includes headers and retransmissions which may be
used by providers to calculate billed amounts.
The metrics are set to 0 after reset or after the metrics are reported to Remote
Manager.
The reported metrics are as follows:
n
" metrics / tcp / sent ": TCP data sent from the device.
n
" metrics / tcp / received ": TCP data received.
3
UDP data estimated transfer counters.
Set bit 3 to enable reporting of data counters for UDP traffic.
The data reported is application data and does not include the overhead of the
UDP protocol including headers.
The metrics are set to 0 after reset or after the metrics are reported to Remote
Manager.
The reported metrics are as follows:
n
" metrics / udp / sent ": UDP data sent from the device.
n
" metrics / udp / received ": UDP data received.
4
Link Deactivations.
Set bit 4 to enable reporting the number of internet link deactivations since the
last reset or reporting.
The metrics are set to 0 after reset or after the metrics are reported to Remote
Manager.
This is reported to the "
metrics / link_deactivations " Data Stream in Remote
Manager for the devices.
5
Sleep metrics counter.
Set bit 5 to enable reporting of the number of times the device has slept since the
last report.
This works in conjunction with the
HF command.
The value is reset to 0 after reset or after the metrics are reported to Remote
Manager.
Default
0x0
ER (Remote Manager TCP Port Override)
Use this command to specify a TCP port other than the default Remote Manager TCP port. The
defaults are 0xC7D when unencrypted and 0xC7F when TLS is enabled.
n
Value is 0: The default Remote Manager TCP port is used.
n
Value is non-zero: Specify the TCP port that should be used. The default Remote Manager
TCP port is overridden.
Parameter range
0x0 - 0xFFFF