Digi XBee 3 Cellular LTE-M, User Manual, Page: 188 / 331

AT commands Cellular commands
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide 188
Note You can also send DT , which acts like DT=0 .
Default
0
AN (Access Point Name)
Specifies the packet data network that the modem uses for Internet connectivity. This information is
provided by your cellular network operator. After you set this value, applying changes with
AC (Apply
Changes) or CN (Exit Command mode) triggers a network reset.
See Network connection issues if the XBee Smart Modem is not joining the network.
Parameter range
1 - 100 ASCII characters
Default
-
CP (Carrier Profile)
Configures the cellular component to select network operator settings (RF bands, packet data
configuration) for various networks.
The 1 (No Profile) setting should be used if the module is not able to join the network because the
underlying cellular modem does not have a predefined profile that supports the inserted SIM card. The
1 (No Profile) setting does not use any predefined profiles, which forces the module to attempt to
join an appropriate network based on the module's current configuration. This configuration works in
conjuction with the following commands:
BM (Bandmask) (LTE-M) , BN (Bandmask) (NB-IoT) , N#
(Preferred Network Technology) .
Changes to the value only take effect on boot so a reboot or power cycle is required for any changes
to become active.
Parameter range
0 - 3
Value Description
0
Autodetect from inserted ICCID (SIM). This is the default.
Setting to
0 increases the boot time.
1 No Profile
2 AT&T
3
Verizon
Note This value should only be used with Verizon home network SIM cards. Setting the
value to 3 with other SIM cards may adversely affect network registration and activity.
Default
0