Digi TX54, User Manual

Page: 647 / 1087

Services Configure a multicast route
TX54 User Guide 647
Show NTP information
1. Log into the TX54 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Use the show ntp command at the system prompt:
> show ntp
NTP Status Status
-----------------
Status
: Up
Sync Status : Up
Remote Refid ST T When Poll Reach Delay
Offset Jitter
---------------- ------------- -- - ---- ---- ----- ------ -----
- ------
*ec2-52-2-40-158 129.6.15.32 2 u 191 1024 377 33.570
+1.561 0.991
128.136.167.120 128.227.205.3 3 u 153 1024 1 43.583 -
1.895 0.382
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure a multicast route
Multicast routing allows a device to transmit data to a single multicast address, which is then
distributed to a group of devices that are configured to be members of that group.
To configure a multicast route:

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System . Under Configuration , click Device Configuration .
The Configuration window is displayed.