Digi TX54, User Manual

Page: 611 / 1087

Services Location information
TX54 User Guide 611

Command line
1. Log into the TX54 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a geofence:
(config)> add service location geofence name
(config service location geofence name )>
where name is a name for the geofence. For example:
(config)> add service location geofence test_geofence
(config service location geofence test_geofence)>
The geofence is enabled by default. To disable:
(config service location geofence test_geofence)> enable false
(config service location geofence test_geofence)>
4. Set the amount of time that the geofence should wait between polling for updated location
data:
(config service location geofence test_geofence)> update_interval value
(config service location geofence test_geofence)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the format
number { w|d|h|m|s }.
For example, to set update_interval to ten minutes, enter either 10m or 600s :
(config service location geofence test_geofence)> update_interval 600s
(config service location geofence test_geofence)>
The default is 1m (one minute).
5. Set the boundary type for the geofence:
(config service location geofence test_geofence)> boundary value
(config service location geofence test_geofence)>