Digi TX54, User Manual

Page: 1081 / 1087

Command line interface Command line reference
TX54 User Guide 1081
ssh
Use SSH protocol to log into a remote server.
Syntax
ssh <host> <user> [ port INTEGER] [ command STRING]
Parameters
host: The hostname or IP address of the remote host.
user: The username to use when connecting to the remote host.
port: The SSH port to use to connect to the remote host. (Minimum: 1, Maximum: 65535, Default: 22)
command: The command that will be automatically executed once the SSH session to the remote
host is established.
system backup
Save the device's configuration to a file. Archives are full backups including generated SSH keys and
dynamic DHCP lease information. Command backups are a list of CLI commands required to build the
device's configuration.
Syntax
system backup [ type <custom-defaults|cli-config|archive>] [ path STRING]
[ passphrase STRING] [ remove <custom-defaults>]
Parameters
type: The type of backup file to create. Archives are full backups including generated SSH keys and
dynamic DHCP lease information. CLI configuration backups are a list of CLI commands used to build
the device's configuration. (Default: archive)
path: The file path to save the backup to. (Default: /var/log/)
passphrase: Encrypt the archive with a passphrase.
remove: Remove a backup file.
system disable-cryptography
Erase the device's configuration and reboot into a limited mode with no cryptography available. The
device's shell will be accessible over Telnet (port 23) at IP address 192.168.210.1. To return the device
to normal operation, perform the configuration erase procedure with the device's ERASE button twice
consecutively.
Syntax
system disable-cryptography
Parameters
None
system duplicate-firmware
Duplicate the running firmware to the alternate partition so that the device will always boot the same
firmware version.