Digi TransPort WR11, User Manual

Page: 514 / 866

Configure time bands Timeband page parameters
Digi TransPort WR Routers User Guide 514
Timeband page parameters
The Timeband parameters pages configure one time band instance each. Configuration is
controlled by a table, with the following parameters. You can configure up to ten time band
transitions.
Days
A set of checkboxes for selecting the days of the week to which the time band transitions apply.
You can select days individually or in groups for convenience. To select all the days of the week,
check the All checkbox. To select the weekend only, check the
Sat->Sun checkbox. To select weekdays only, check the Mon->Fri checkbox.
Time
The transition time, specified in 24-hour format with a colon separator between hours and
minutes.
State
The routing state, which can be On or Off . For convenience, this parameter toggles state for
each new addition; if an On transition is configured, the default state for the next addition is Off .
Clicking the Add button adds the entry into the table. Once an entry is added to the table,
remove it by clicking the associated Delete button. To activate this time band instance, navigate
to the associated PPP Timeband configuration page, and click the Enable checkbox, or enter
the equivalent command line command.