Digi TransPort WR11, User Manual

Page: 223 / 866

Configure network interfaces Configure DSL interfaces
Digi TransPort WR Routers User Guide 223
Advanced DSL parameters
Operational mode
The connection mode for the DSL link. The following options are available (default is Multi
mode).
Load DSL firmware from flash file ‘dspfw.bin’ (if present)
Enables use of alterADSL driver firmware and should only be enabled on the advice of
the technical support team. This option also requires that an additional file be loaded onto the
router.
Enable watchdog
This setting should only be enabled on the advice of Digi Technical Support.
Manage this PVC using ATM OAM cells
Using Alarm indication signal (AIS) cells downstream and Remote defect indication (RDI) cells
upstream, the router can detect faults between the connecting points of the VP/VC and suspend
transfer of ATM cells until the VC fault condition is cleared.
Values Equivalent web parameter
Multi-mode For Annex A models (such as PSTN / POTS) this option provides automatic
selection between G.dmt, G.lite and ANSI (in the order listed).
For Annex B models (such as ISDN) this option provides automatic selection
between G.dmt (in the order listed)
ANSI Annex A only-attempt to connect in ANSI T1.413 mode
G.dmt Attempt to connect in ITU G.992.1 G.dmt mode
G.lite Annex A only-attempt to connect in ITU G.992.2 G.lite mode
ADSL2 Connect using ADSL2
ADSL2+ Connect using ADSL2+