Digi TransPort WR11, User Manual

Page: 216 / 866

Configure network interfaces Configure DSL interfaces
Digi TransPort WR Routers User Guide 216
Configure DSL interfaces
Router models incorporating a DSL broadband interface includes a configuration page having the
title shown above. By default, the configuration in this section is suitable for the majority of ADSL
service providers in the UK. However, advanced users or users outside of the U.K. may wish or need
to adjust some of the parameters.
Enable DSL
Enables or disables the use of DSL/ADSL functionality on the router.
Configure PVC
Select the required PVC instance from the drop-down selection box. Subsequent settings applies
to the selected instance (see below).
PVC parameters
The PVC (Permanent virtual circuit) parameters are described here.
Enable this PVC
Check this box to enable PVC settings.
Encapsulation
The method of encapsulation to use when transporting data over this APVC. The appropriate
value can be selected from a drop list which includes the following options:
To use PPPoA or PPPoE encapsulation, one of the available PPP instances must first be
configured to use this APVC instance as its Layer 1 interface on the associated Configuration >
Interfaces > PPP > PPP n > Advanced page .
VPI
The Virtual Path Identifier for this APVC in the range 0-255 .
Option Description
PPPoA VC-Mux RFC 2364 VC-multiplexed PPP over AAL5
PPPoA LLC RFC 2364 LLC encapsulated PPP over AAL5
PPPoE VC-Mux RFC 2516 VC-multiplexed PPP over Ethernet
PPPoE LLC RFC 2516 LLC encapsulated PPP over Ethernet
Bridged Ethernet VC-Mux RFC 2684 VC-multiplexed bridged Ethernet
Bridged Ethernet LLC RFC 2684 LLC encapsulated bridged Ethernet
Routed IP VC-Mux RFC 1483 VC multiplexing routed IP over ATM
Routed IP LLC RFC 1483 LLC encapsulated routed IP over ATM