Digi TransPort WR11, User Manual

Page: 214 / 866

Configure network interfaces Configure mobile (cellular) interfaces
Digi TransPort WR Routers User Guide 214
Configure and test W-WAN models from the web interface
To configure the TransPort router for the correct APN and PIN code, if any.
1 Make sure the router’s mobile settings is correctly configured as needed, through the mobile
settings described earlier in this section.
2 Power up the router and test the connection to the wireless network.
3 If you have correctly configured everything, the W-WAN SIM indicator on the front panel should
illuminate green to show that a W-WAN enabled SIM card is present.
4 The router will now attempt to log on to the specified mobile network. If it is able to do so, the
W-WAN NET indicator will illuminate steady.
5 Data passing to and from the network is reflected by the status of the DAT indicator, which
flashes green.
6 If you cannot connect to the network, go to the Management > Network Status > Interfaces >
Mobile web page.
7 Click Refresh . A page similar to the following should be displayed. For more on the Signal
Strength status and value displayed, see Signal strength indicators on the Mobile status page .