Digi TransPort WR11, User Manual

Page: 108 / 866

Use the command-line interface Log in to the command line interface
Digi TransPort WR Routers User Guide 108
Log in to the command line interface
When the login prompt appears on the command line, enter the default user name and password:
▪
Username: username
▪
Password: password
Note For security purposes, Digi recommends changing the username and password for all users
away from their defaults. See Change the default username and password for a user .
Exit the command line interface
To exit the command line interface, enter the exit command.
Commands and the active port
When entering AT or text commands, in most cases, the command only affects the settings for
the active port . This is usually the port to which you are physically connected but you may, if
necessary, set the active port to another port of your choice using the AT\PORT=N command where
N is a port number from 0-3 .
When commands take effect
All entered commands take effect immediately.
View current configuration changes
To view the current configuration settings, enter the following command:
config c show
Save changes
To save changes made to the router, enter the following command:
config 0 save