Wi-Fi
Configure an open Wi-Fi access point
LR54 User Guide
270
5. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure an open Wi-Fi access point
This procedure configures a Wi-Fi access point that does not require a password for client
connections.
By default, the LR54W device comes with two preconfigured access points,
Digi AP (Wi-Fi1)
and
Digi
AP (Wi-Fi2)
. You cannot delete default access points, but you can modify them or you can create your
own access points.
Required configuration items
n
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure open security for the access point.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
Configure a Local Area Network (LAN)
and
for more information.
Additional configuration items
n
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
communicate with each other.
n
The amount of time to wait before changing the group key.
To configure a Wi-Fi access point with no security:
Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
Remote Manager:
a. Locate your device as described in
Use Digi Remote Manager to view and manage your
b. Click the
Device ID
.
c. Click
Settings
.
d. Click to expand
Config
.
Local Web UI:
