Digi NetSilicon Connectware Connect Series, User Manual

Page: 26 / 37

Chapter 5 Configuring GPIO Pins and Alarms 27
5. If you want to trigger email alarms based on the state of a
port, see the following discussion.
Configuring Alarms
Introduction
This section describes how to configure the module to send
email alarms when a GPIO pin signals that an event has
occurred on the device.
Procedure
1. Access the web interface by entering the module’s IP
address in a browser’s URL window.
2. Choose Alarms from the Management menu.
3. Check Enable Sending Alarms.
4. Configure SMTP alarms settings and then click Save. Use
the following table for information on configuration fields.
Setting Description
SMTP server
address
Is the email address of the email server
From user Is the email address of this client
Enable alarm Must be checked to activate this alarm
Trigger con-
dition
Determines the GPIO pins and conditions that trigger
an alarm. Here is how this works:
•
The trigger can be any combination of pins.
• An x means do not use this pin as part of the trig-
ger mechanism.
• A 1 means trigger the alarm on a raised signal.
• A 0 means trigger the alarm on a lowered signal.
Trigger Inter-
val Is the period to wait in seconds before sending
another email alarm when an alarm condition persists.
Trigger only
on transition Means trigger the alarm only when the signal on the
pin goes from low to high or high to low.