Digi NetSilicon Connectware Connect Series, User Manual

Page: 12 / 37

Chapter 3 Configuring Network Settings 13
Introduction
This chapter describes how to change network settings. It
assumes that you have assigned initial network settings to
the product as described in "Quick Start Setup" on page 9.
Configuring Network Settings
Introduction
This section provides information on changing network
settings, such as the module’s IP address, subnet mask, and
default gateway.
Procedure
1. Access the web interface by entering the product’s IP
address in a browser’s URL window.
2. Choose Network from the Configuration menu.
3. Choose the Basic tab.
4. Make changes as required and then choose Save. See
your network administrator to gather the information
required to ensure that the product is configured correctly
for your network. See the table that follows for information
on configuration fields.
Chapter 3
C o n f i g u r i n g N e t w o r k S e t t i n g s