Configuration and management
Change the default password for the admin user
IX20 User Guide
38
Feature
Configuration
Security policies
n
Packet filtering allows all outbound traffic.
n
SSH and web administration:
l
Enabled for local administration
l
Firewall zone: Internal
Monitoring
n
Device heath metrics uploaded to Digi Remote Manager at 60 minute
interval.
n
SNMP: Disabled
Serial port
n
Enabled
n
Serial mode: Remote
n
Label: None
n
Baud rate: 9600
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
Change the default password for the admin user
The unique, factory-assigned password for the default
admin
user account is printed on the bottom
label of the device and on the loose label included in the package. When you first log into the WebUI or
the command line, you will be required to change the password for the
admin
user prior to being able
to save any configuration changes.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin
user will revert to the original, factory-assigned default password.
Additionally, for Wi-Fi enabled models, when you first log into the WebUI or the command line, you will
be required the change the SSID and pre-shared key (password) for the preconfigured Wi-Fi access
point. See
Reset default SSID and pre-shared key for the preconfigured Wi-Fi access point
for
instructions.
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click
System
. Under
Configuration
, click
Device Configuration
.
The
Configuration
window is displayed.
