Digi IX20, User Manual

Page: 196 / 726

Wi-Fi Show Wi-Fi access point status and statistics
IX20 User Guide 196
e. Set the IP address and subnet mask of the LAN:
(config network interface LAN2)> ipv4 address address / mask
(config network interface LAN2)>
f. Enable the DHCP server:
(config network interface LAN2)> ipv4 dhcp_server enable true
(config network interface LAN2)>
6. Save the configuration and apply the change:
(config network interface LAN2)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Show Wi-Fi access point status and statistics
You can show summary status for all Wi-Fi access points, and detailed status and statistics for
individual Wi-Fi access points.

WebUI
1. Log into the IX20 WebUI as a user with Admin access.
2. On the main menu, click Status .
3. Under Connections , click Wi-Fi > Access Points .

Command line
Show summary of Wi-Fi access points
To show the status and statistics for Wi-Fi access points, use the show wifi command.
1. Log into the IX20 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type show wifi ap :
> show wifi ap
AP Enabled Status SSID BSSID
-------- ------- ------ ------------- -----------------
my_AP true up my_SSID 01:41:D1:14:36:37
digi_ap true up Digi2 00:40:D0:13:35:36
>