Wi-Fi
Configure a Wi-Fi access point with no security
IX20 User Guide
172
3. Set the transmit power percentage for the radio:
(config)> network wifi radio phy0 tx_power
value
(config)>
where
value
is any integer between 1 and 100 and represents the percentage of transmit
power that the Wi-Fi module should use.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure a Wi-Fi access point with no security
This procedure configures a Wi-Fi access point that does not require a password for client
connections, and uses no security or encryption.
By default, the IX20 device comes with one preconfigured access point,
Digi AP
. You cannot delete
default access points, but you can modify them or you can create your own access points.
Required configuration items
n
Enable the Wi-Fi access point
n
Select a Wi-Fi radio for the access point.
n
The Service Set Identifier (SSID) for the access point.
n
Configure security for the access point to unencrypted.
n
LAN/bridge assignment. Once you configure a Wi-Fi access point, you must assign the Wi-Fi
access point to a LAN interface or to a bridge. See
and
for
more information.
Additional configuration items
n
Determine whether to broadcast the access point's SSID.
n
Determine whether to isolate clients connected to this access point, so that they cannot
communicate with each other.
n
The amount of time to wait before changing the group key.
