Wi-Fi
Configure the Wi-Fi radio's transmit power
IX20 User Guide
170
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. Set channel for the radio:
a. Set the band for the radio:
(config)> network wifi radio phy0 band
value
(config)>
where
value
is either
2400mhz
or
5000mhz
.
b. Set the mode for the Wi-Fi radio. For example:
n
If the Wi-Fi radio has a band of
2400mhz
:
(config)> network wifi radio phy0 2400mhz mode
value
(config)>
where
value
is one of
b
,
bg
,
bgn
,
g
,
gn
, or
n
.
n
If the Wi-Fi radio has a band of
5000mhz
:
(config)> network wifi radio phy0 5000mhz mode
value
(config)>
where
value
is one of
ac
,
acn
, or
n
.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure the Wi-Fi radio's transmit power
The default Wi-Fi transmit power that the Wi-Fi radio will use when in access point or client mode is
100 percent. You can configure the Wi-Fi radio to transmit at a lower power.
WebUI
