Getting started
Introduction
Digi CM User Guide
22
Introduction
This section covers basic configuration topics. Included is information on assigning IP settings,
enabling secure access with the web interface, accessing the unit through SSH, and adding or
removing users.
Note
Initial setup is described in the Quick Start Guide included with the product packaging. A
copy of this document is also available online
Assigning IP settings from the console port
The following steps use the console port to assign IP settings.
Note
The default IP address is 192.168.161.5.
1
Connect the console port on the rear panel of the Digi CM unit to a serial port on a workstation
using the Ethernet console cable and the appropriate console adapter packaged with the the
Digi CM unit. The arrow in the following graphic points to the console port.
2
Configure a terminal emulation program, such as HyperTerminal, using the
following settings:
•
bps = 9600
•
data bits = 8
•
parity = none
•
stop bits = 1
•
flow control = none
3
Establish a connection to the console port and press Enter to get a command prompt.
4
At the login prompt, log in as
admin
. The default password for admin is
admin
.
The Configuration menu appears.
5
Enter the number for Network Configuration.
6
Enter the number for IP configuration.
7
Enter the appropriate parameters for the IP settings.
8
Press ESC when done to return to the main configuration menu.
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
