Configuration menu
Sniff sessions
Digi CM User Guide
163
5
Use the ESC key when all parameters are entered to return to the main menu.
6
Choose Save changes.
Sniff sessions
To configure a port or all ports for sniff users, do the following:
1
Access the configuration menu.
2
Choose Serial port configuration.
3
Choose an individual port number or 0 (zero) for all ports > User access control.
4
Choose User Access Control.
5
Choose Enable/Disable Sniff Mode.
6
Choose a menu item and enter the desired parameters.
7
Use the ESC key when all parameters are entered to return to the main menu.
8
Choose Save changes.
For information on entering a sniff session, see the next section,
Summary of Contents for Digi CM 16
Page 1: ...User Guide Digi CM 8 port 16 port 32 port and 48 port...
Page 63: ...Digi CM User Guide 63 User administration Administer users 64...
Page 130: ...Power Controller Cascade multiple Digi RPM units Digi CM User Guide 130...
Page 131: ...Digi CM User Guide 131 Port clustering Introduction 132 Configure port clustering 132...
