Interfaces
Wide Area Networks (WANs)
Digi Connect EZ Mini User Guide
69
5. Delete the target:
(config network interface my_wan> del ipv4 surelink target 1
(config network interface my_wan)>
6. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
7. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure a Wide Area Network (WAN)
Configuring a Wide Area Network (WAN) involves configuring the following items:
Required configuration items
n
The interface type:
Ethernet
.
n
The firewall zone:
External
.
n
The network device that is used by the WAN.
n
Configure the WAN as a DHCP client.
Additional configuration items
Additional IPv4 configuration:
n
The metric for IPv4 routes associated with the WAN.
n
The relative weight for IPv4 routes associated with the WAN.
n
The IPv4 management priority of the WAN. The active interface with the highest management
priority will have its address reported as the preferred contact address for central
management and direct device access.
n
The IPv4 Maximum Transmission Unit (MTU) of the WAN.
o
When to use DNS servers for this interface.
o
Whether to include the Connect EZ device's hostname in DHCP requests.
o
SureLink active recovery configuration. See
Configure SureLink active recovery to detect WAN
for further information.
IPv6 configuration:
n
The metric for IPv4 routes associated with the WAN.
n
The relative weight for IPv4 routes associated with the WAN.
n
The IPv4 management priority of the WAN. The active interface with the highest management
priority will have its address reported as the preferred contact address for central
management and direct device access.
