Diagnostics
Configure options for the event and system logs
Digi Connect EZ Mini User Guide
583
n
To disable status event messages:
(config system log remote 0)> status false
(config system log remote 0)>
n
To disable informational event messages:
(config system log remote 0)> error false
(config system log remote 0)>
4. Set the port number to use for the syslog server:
(config system log remote 0)> port
value
(config system log remote 0)>
where
value
is any integer between
1
and
65535
. The default is
514
.
5. Set the IP protocol to use for communication with the syslog server:
(config system log remote 0)> protocol
value
(config system log remote 0)>
where
value
is either
tcp
or
udp
. The default is
udp
.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure options for the event and system logs
The default configuration for event and system logging is:
n
The heartbeat interval, which determines the amount of time to wait before sending a
heartbeat event if no other events have been sent, is set to 30 minutes.
n
All event categories are enabled.
To change or disable the heartbeat interval, or to disable event categories, and to perform other log
configuration:
WebUI
