User authentication
Configure serial authentication
Digi Connect EZ Mini User Guide
457
(config)> add auth method end ldap
(config)>
14. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
15. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure serial authentication
This section describes how to configure authentication for serial access.
WebUI
1. Log into the Connect EZ WebUI as a user with full Admin access rights.
2. On the menu, click
System
. Under
Configuration
, click
Device Configuration
.
The
Configuration
window is displayed.
3. Click
Authentication
>
Serial
.
4. (Optional) For
TLS identity certificate
, paste a TLS certificate and private key in PEM format.
If empty, the certificate for the web administration service is used. See
for more information.
5. For
Peer authentication
, select the method used to verify the certificate of a remote peer.
6.
Include standard CAs
is enabled by default. This allows peers with certificates that have been
signed by standard Certificate Authorities (CAs) to authenticate.
7. Click to expand
Custom certificate authorities
to add the public certificates of custom CAs.
a. For
Add CA certificate
, type the name of a custom CA and click
.
b. Paste the public certificate for the custom CA in PEM format.
c. Repeat for additional custom CA certificates.
8. Click to expand
Peer certificates
to add the public certificates of trusted peers.
a. For
Add Peer certificate
, type the name of a trusted peer and click
.
b. Paste the public certificate for the trusted peer in PEM format.
c. Repeat for additional trusted peer certificates.
