Configuration and management
Configuration methods
Digi Connect EZ Mini User Guide
39
5. Click
Apply
to save the configuration and apply the change.
Command line
1. Log into the Connect EZ command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
admin
to access the Admin CLI.
2. At the command line, type
config
to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password
new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configuration methods
There are two primary methods for configuring your Connect EZ device:
n
Web interface.
The web interface can be accessed in two ways:
l
Central management using the Digi Remote Manager, a cloud-based device management
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your Connect EZ device and use
the configuration as a basis for a profile which can be applied to other similar devices. See
for more information about using the Remote Manager to
manage and configure your Connect EZ device.
l
The local web interface. See
for more information about using the
local web interface to manage and configure your Connect EZ device.
