Digi AnywhereUSB Plus, User Manual, Page: 437 / 815

System administration Configure the speed of your Ethernet ports
AnywhereUSB® Plus User Guide 437
Configure the speed of your Ethernet ports
You can configure the speed of your AnywhereUSB Plus device's Ethernet ports.
É
WebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System . Under Configuration , click Device Configuration .
The Configuration window is displayed.
3. Click Network > Device .
4. Click to expand the Ethernet port to be configured.
5. For Speed , select the appropriate speed for the Ethernet port, or select Auto to automatically
detect the speed. The default is Auto .
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network device eth_port value
where:
n
eth_port is the name of the Ethernet port (for example, eth1 )
n
value is one of:
l
10 —Sets the speed to 10 Mbps.
l
100 —Sets the speed to 100 Mbps.
l
1000 —Sets the speed to 1 Gbps. Available only for devices with Gigabit Ethernet
ports.
auto —Configures the device to automatically determine the best speed for the
Ethernet port.