Digi AnywhereUSB Plus, User Manual, Page: 253 / 815

Services Location information
AnywhereUSB® Plus User Guide 253
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the GNSS module:
n To enable the module:
(config)> service location gnss true
(config)>
n
To disable the module:
(config)> service location gnss false
(config)>
4. Set the amount of time that the AnywhereUSB Plus device will wait before polling location
sources for updated location data:
(config)> service location interval value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number { h|m|s }.
For example, to set interval to ten minutes, enter either 10m or 600s :
(config)> service location interval 600s
(config)>
The default is 10 seconds.
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Configure the device to use a user-defined static location
You can configured your AnywhereUSB Plus device to use a user-defined static location.
É
WebUI