Digi 70002405, User Manual

Page: 73 / 163

Configure the device using the ConnectPort LTS web interface Configuration through the web interface
Digi ConnectPort LTS User Guide 73
n
Send data to the following network services : A list of servers or devices to send data to
using UDP. To add a new destination enter the following information and click Add .
l
Description : A description of the server or device (16 characters or less).
l
Send To : The IP address or DNS name to send data to.
l
UDP Port : The port number to send data to. If you are sending data to another Digi device
server use the raw UDP port number for its serial port. This is usually 2101 for port 1. The
format for this port number is as follows:
21<serial port number>
Replace <serial port number> is the Digi serial port number. For example, 2101 applies to
serial port 1, 2110 applies to serial port 10, and 2116 applies to serial port 16.
n
Send data under any of the following conditions :
l
Send when data is present on the serial line : Send the data to the network
destinations when a string of characters is detected in the serial data. To enter non-
printable characters, use these key sequences:
Character
Key
Sequence
hexadecimal
values
\xhh
tab \t
line feed \n
backslash \\
l
Match string : A 1 to 4 character string. This is usually the newline character sequence but
can also be a custom string of 1 to 4 characters.
l
Strip match string before sending: Search for the string specified in the Match String
field before sending the data and strip the string from the string from the data before it is
sent to the destination.
l
Send after the following number of idle milliseconds : Send the data after the specified
number of milliseconds have passed with no data received on the serial port.
l
Send after the following number of bytes : Send the data after the specified number of
bytes have been received on the serial ports.
Basic serial settings
The basic serial port settings must match the serial settings of the connected device. If you do not
know these settings consult the documentation that came with your serial device. These serial