background image

Mounted Exterior Keypad

Features

The Mounted Exterior Keypad is a
battery-operated device that will
operate a Digi-Code receiver or a
Stanley garage door opener using
a four-digit PIN (Personal
Identification Number). 
Pressing
four preprogrammed numbers on
the keypad sends a radio signal to
the receiver or door opener that
controls the garage door or gate
operator. See Figure 1.

Pressing any key will light the keypad.
The keypad works with both Digi-Code Receivers (DC-5200 & DC-5202) and
Stanley Digital type door openers.(DC-5202 ONLY)
The keypad will store the last PIN entered in its memory, even if the battery is
removed.
Pressing any key within 30 seconds after the door has been activated will
activate the door again.

• Mount the keypad OUT OF THE REACH OF CHILDREN at least five feet

above the ground.

• NEVER allow children to operate the keypad.

• Disconnect power from the door opener before 

installation.

• Wear safety glasses to protect your eyes 

during installation.

Section 1: General Installation of Your
Exterior Keypad

Tools Required:
• Drill with 1/8" bit
• Flathead screwdriver
• Pencil
• Measuring tape

Figure 1

Figure 2

1. Choose a location that will not interfere with

the normal operation of the door or gate. See
Figure 2.

2. Hold the keypad at the selected location.

Using your pencil, mark the wall at the center
on the top of the unit.

3. Drill a 1/8" hole 3/4" directly below this mark.

See Figure 3.

4. Tighten a screw in the hole until the head is

sticking out about 1/16".

5. Hang the unit on the screw. Adjust screw as

required for a snug fit.

6. Remove the battery cover to expose the 

second screw hole. See Figure 4.

7. Mark the position of the second screw with

the pencil through the screw hole.

8. Drill another 1/8" hole for the second screw.
9. Tighten the second screw in the hole.

10. Install the battery and replace the battery cover.

1

2

Figure 4

Figure 3

72-5200 C

WARNINGS

DC-5200A - 300MHz
DC-5202A - 310MHz

(

)

Section 2: Programming to a Digi-Code Receiver (Models DC-5200 & DC-5202) or
a Stanley Digital type Garage Door Opener (Model DC-5202 ONLY).

1. Refer to the DIP switch settings in your receiver

or the back of your opener and take notes on the
chart to the upper right which switches are in the
“On” or “Closed” positions. You must have at least
1 of the 10 switches closed.

2. Press the Radio Learn button twice. The light by the

Digi-Code label will come on and stay on.

3. Press the numbers that represent the closed

switches on the receiver or the garage door opener
(i.e. if switches 2,4, and 6 are closed, enter 246. For
switch position 10, use the 0 key).

4. Press the Radio Learn button once.
5. To test if you have properly programmed in the

radio code, enter the factory set PIN (1-2-3-4). The
receiver or opener should operate.

Figure 7

Reviews: