2
PM-000150-C Kopenn Auger Drive Service and Repair Manual - March 2018
PD MODEL
OIL CAPACITY (LITRE)
PD12HD-21
1.45
PD22-20
2.85
PD50-20
6.4
TK25-20
7.0
LUBRICATION & MAINTENANCE
USE QUALITY EXTREME
PRESSURE GEAR OIL
(EP ISO 320 GRADE - SYNTHETIC OIL)
NOTE
It is also recommended that unit be partially disassembled to inspect gears and bearings at 2 year intervals.
Oil changes must be performed by a Authorised Service Agent. Please Contact Digga for your nearest service location.
SINGLE & DOUBLE PLANETARY AUGER DRIVES
This manual is intended to be used by persons with reasonably mechanical skills and understanding of mechanical components.
This manual will assist in the disassembly and assembly of the above model Planetary Auger Drives. Item numbers, indicated in pa-rentheses
throughout this manual, refer to the exploded parts breakdown drawing. Individual customer specifications (mounting hood, output shaft etc.) may
vary from exploded drawing and standard part numbers shown. Contact Digga Australia for enquiries.
For any spare or replacement parts, contact Digga Service and Spares or a local Digga representative. For identification purposes always try to have
available the auger drive unit type and serial number. This information may be necessary for verification of any component part numbers. Component
part numbers and/or manufacturing gear set numbers may be stamped on individual parts. This information may also be helpful in identifying
replacement components.
CHANGING GEAR OIL
Change the gear oil after 6 months or 80 hours of moderate operation, then every 500 hours or 12 months whichever comes first
.
MODERATE OPERATING CONDITIONS
SEVERE OPERATING CONDITIONS
*
FIRST OIL CHANGE
Within 3 months
OR
initial 50 hours of use
Within the first 30 hours of use
2ND OIL CHANGE PLUS SUBSEQUENT OIL CHANGES
After 500 hours or 12 months of use
After 300 hours of use thereafter (Drive requires a major
stripdown, inspection and rebuild)
GEARBOX OIL:- - CASTROL ALPHASYN ISO SP 320 (MINERAL) OR EQUIVALENT
*
SEVERE OPERATING CONDITIONS:- AMBIENT TEMPERATURES BELOW 0° (32°F) & ABOVE 40°C (104°F). WORKING IN HARD GROUND.
EXTENDED AND CONTINUOUS HOURS OF OPERATION.
THE GEARBOX OIL CAPACITY IS ENGRAVED ONTO THE SERIAL TAG LOCATED ON THE TOP OF THE HOOD.
Initial (Bed-in) oil change:
•
The first oil change must be carried out within the first 50 hours of use under
MODERATE OPERATING CONDITIONS.
Thereafter, every 500 hours.
•
Change the gear oil after the first 30 hours of
SEVERE OPERATING CONDITIONS
*
. (i.e. severe ambient temperature conditions of +40°C or
below 0°C, when augering, screw piling or core barrelling in hard ground.) Thereafter, every 300 hours.
