SBIG STC-428-OEM CAMERA
USER’S MANUAL
10
1.3 Installing the Hardware
This section details the steps required to connect an STC-428-OEM
camera.
1.
Install the ferrite snap-on chokes
at convenient positions along both
the USB cable and the DC power cable, preferably close to the
camera ends of these cables. Open a choke and lay the cable into the
channel, then snap the choke halves together.
2.
Attach the cabling:
CAUTION:
Never “hot plug” the cables into or from the units. Always
disconnect power before connecting or disconnecting any cables.
•
Attach the USB cable between the USB connector and your
computer.
