“SUZO” - Rev. 01 22/09/2017
25
3.4 TABLE STRUCTURE ASSEMBLY
Fig. 3.4
1. Remove the electronics compartment cover by pressing on the central tabs.
2. Remove the beam’s end caps.
3. For each side, tighten 4 “TBEI CH4 M6X14 Ø13” screws to detach the beam from the leg, as
in Fig. 3.4.
4. Run the leg connector inside the beam, as in Fig. 3.4 until you reach the slot in the middle of
the beam.
.
Fig. 3.5
•
Insert the two leg connectors in doors M1 and M2 of the control unit, as in Fig. 3.5.
