CMi4160
– LoRaWAN
®
Module
3
02/2021
1
DOCUMENTS NOTES
All information in this user guide, including product data, diagrams, charts, etc. represents information
on products at the time of publication, and is subject to change without prior notice due to product
improvements or other reasons. It is recommended that customers contact Diehl Metering GmbH for
the latest product information before purchasing a CMi Series product.
The documentation and product are provided on an “as is” basis only and may contain deficiencies or
inadequacies. Diehl Metering GmbH takes no responsibility for damages, liabilities or other losses by
using this product.
1.1
COPYRIGHT AND TRADEMARK
© 2020, Diehl Metering GmbH. All rights reserved. No part of the contents of this user guide may be
transmitted or reproduced in any form by any means without the written permission of Diehl Metering
GmbH.
2
IMPORTANT USAGE AND SAFETY INFORMATION
The following safety precautions must be observed during all phases of the operation, usage, service
or repair of any CMi Series product. Users of the product are advised to convey the information to
users and operating personnel and to incorporate these guidelines into all user guides supplied with
the product. Failure to comply with these precautions violates safety standards of design, manufacture
and intended use of the product. Diehl Metering GmbH assumes no liability for customer’s failure to
comply with these precautions.
CMi4160 receives and transmits radio frequency energy while switched on. Remember that
interference can occur if the product is used close to TV sets, radios, computers or inadequately
shielded equipment. Follow any special regulations and always switch off the product wherever
forbidden, or when you suspect that it may cause interference or danger.
3
USING THIS USER GUIDE
3.1
PURPOSE AND AUDIENCE
This user guide provides all information needed to mount, deploy and configure CMi4160 and targets
installers and system integrators.
3.2
SYMBOLS
The following symbols are used throughout the user guide to emphasize important information and
useful tips:
The Note symbol is used to mark information that is important to take into
consideration for safety reasons or to assure correct operation of the meter
connectivity module.
The Tip symbol is used to mark information intended to help you get the most out of
your product. It can for example be used to highlight a possible customization option
related to the current section.
