2.4.7
Safe Lock
The safe used is CEN 1, 40 mm thick.
The following locks are available:
• Mechanical combination lock
• Electronic combination lock
• Cencon electronic lock
• Mechanical keylock
Electronic locks are available with such features as a single combination,
dual combinations, remote access combination, etc. Refer to Section 3.11 for
information on using the electronic safe door lock to open and close the safe door.
2.4.8
Terminal Switches
Terminal switches monitor the open or closed position of the terminal fascia,
upper chassis rear door, and safe door.
2.4.9
Alarm Sensors
Alarm sensors with a network interface report to a network and send alarm
signals to an alarm-monitoring system. Alarm sensors report during or after
one of the following events:
• The safe door is opened or closed (door status).
• The safe door is opened, but the combination was not entered (burglary)
available on single combination mechanical lock and on electronic locks.
• The duress combination is entered (anti-ambush) available on single
combination mechanical lock and on electronic locks.
• Primary bolt work position sensor detects whether the bolt work is open or
closed.
• Secondary lock bolt position sensor.
Alarm sensors with a network interface provide their own battery backup. The
terminal uses the safe door switch to distinguish between an authorized or
unauthorized entry before sending an alarm signal.
2.4.10 Seismic Detectors
Seismic detectors sense physical blows to the terminal safe. Alarm sensors with a
network interface must be present for the seismic detectors to function.
2.4.11 Third Party Alarms
Institutions may want to install their own alarm systems within the safe. An area
within the safe is designated for third party alarm installation.
2-34
Copyright ©Diebold, Incorporated (7/2015, 3/2017) - All Rights Reserved
Copyright ©Diebold Nixdorf (4/2020) - All Rights Reserved
TP-821813-001B