19
19 Changing memory extensions
Switch off the device and disconnect the mains plug.
CAUTION
Use ESD equipment.
Disengage the two knurled screws at the rear of the BEETLE /M-III (see chapter "Opening the BEETLE /
M-III"). Slide the housing cover from the front guide slightly and lift it off upwards. Detach the cables that
run over the air duct on the right-hand side of the motherboard. Grasp the air duct and pull it upwards (1)
so that you can access the RAM socket on the motherboard. The removal of the air duct does not apply
to a BEETLE /M-III with an O1 motherboard. Open the latching mechanism outwards on both sides of
the RAM socket (2).
The RAM strip disengages from the socket and can be removed.
Insert the new RAM strip into this memory socket. The coding of the RAM strip (indentation) prevents in-
correct insertion.
NOTE
Please note that the bottom memory socket must always be inserted first.
01750341829F
19-1
Summary of Contents for BEETLE/M-III
Page 16: ...Before switching on Press this forward so that the cable cover closes flat 01750341829F 6 5...
Page 34: ...Removing the housing cover Lift off the cover upwards Set it aside 01750341829F 12 2...
Page 45: ...Storage Media 01750341829F 13 11...
Page 61: ...Accumulator optional The UPS monitor opens 01750341829F 18 9...