18
18 Accumulator (optional)
The accumulator bypasses an eventual power failure for up to 15 minutes and enables a controlled ter-
mination of the POS program (see below "Safety in the event of power failure").
For the operation of an accumulator, the BEETLE /M-III must be equipped with a special UPS power
supply unit.
WARNING
Danger of injury!
An explosion hazard exists if the accumulator is replaced incorrectly. Only identical types
or by types recommended by the manufacturer are permitted as replacements for the ac-
cumulator.
18.1
18.1 Safety in the event of power failure
The charging time of the battery is approx. 6 hours after commissioning. The battery will only be charged
if the system is switched on and the system software (Wincor UPS-Software under Windows/Linux) is
configured and loaded (trickle charging also takes place in standby mode to prevent the NiMh cells from
self-discharging).
The system remains fully functional for approx. 15 minutes after a failure of the supply voltage. The en-
ergy required for further operation is then supplied by the battery, the failure of the system voltage is by-
passed for a certain period and the system is shut down in the event of a low battery charge level, de-
pending on the software used (DN UPS Windows/Linux driver).
Peripherals with a dedicated power supply unit (e.g. VGA monitor) are not supplied with voltage in the
event of a power failure.
01750341829F
18-1
Summary of Contents for BEETLE/M-III
Page 16: ...Before switching on Press this forward so that the cable cover closes flat 01750341829F 6 5...
Page 34: ...Removing the housing cover Lift off the cover upwards Set it aside 01750341829F 12 2...
Page 45: ...Storage Media 01750341829F 13 11...
Page 61: ...Accumulator optional The UPS monitor opens 01750341829F 18 9...