52
Technical manual: SQUARE 940-2
DICTATOR Technik GmbH · +49 (0)821 246730 · [email protected] · www.dictator.de · 22.06.22
7.2 PREPARATION
Indication
Action
Switching on for
the first time:
After switching on the controller for the first time, the status “E15“ = “Door
positions missing“ appears in the ready menu.
These are programmed via the Quick Setup, as described below.
Setting
functionrelevant
parameters:
Before the actual commissioning, the following function-relevant parameters
must be set:
Choose here in the sub-item “Type“ “Limit Switches“. When using limit switch-
es, the pulse number 5 must be entered. This is entered under “Pulse Count“.
Enter the corresponding motor speed here. This can be found on the rating
plate of the motor. The speed is entered in the subitem “Motor speed“.
