OPERATOR’S MANUAL
ISO
6
Version 4 Quick Start Guide
CONTROLS / 15
6011662 Rev B
8. Press the
START
button and the valve calibration
immediately begins. The calibration runs using the new max
flow value.
Figure 10
Limit Output (Granular)
GRANULAR SPREADER CALIBRATION
NOTE
Refer to the System Tests section for using a remote test
switch during a spreader calibration.
A Spreader Constant Calibration requires a catch test to
determine the spreader constant.
This function is only
available for granular seed and fertilizer applications.
PERFORM A SPREADER CALIBRATION
IMPORTANT
A valve calibration should be performed before a
spreader calibration.
1. Load hopper with material.
2. Move implement to raised position.
3. Apply tractor brakes and lock in applied position.
4. Put transmission in park or in a locked, neutral position.
5. Engage hydraulic system.
6. Run engine at normal operating RPM until hydraulic fluid is
at normal operating temperature.
7. At the Controls screen, press the
SPREAD CAL
button.
