SERVICE
EN
DiBO 33
Service
GENERAL
all maintenance activities must happen at an disconnected machine and
hoses without pressure. allow to cool down the cleaner before performing
maintenance activities! Checking the electric components can happen
exclusively by an expert. Exclusively accessories and replacement components
which have been approved by the manufacturer can be used. Directly after
the activities all securities- and protection parts must be assembled, before
the machine is put in functioning. “a golden rule” that contributes to a perfectly
working machine with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the “know-how” of DiBo a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBo technicians by
means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1
General
Check daily by means of the maintenance diagram the high pressure cleaner.
you find the maintenance diagram on the following pages. Check even all
transmission belts on good tension and possible defects. If this case is not, then
best consult the proper maintenance technicians.
PAY ATTENTION: Take care that the transmission belts are not in
movement and observe the applying safety standards! Always secure
the trailer with wheel blocks before starting any maintenance works!
2
Periodic maintenance
DESCRIPTION
PERIOD
Check the electric cables, high & low pressu-
re hoses, couplings and control of the oil level.
Check the wheel bolts/ Ball clutch/plug/lights/
brake lines/good tyre pressure of the trailer
after each use
Refreshing pump oil
First 50 hours
Refreshing reduction gearbox oil
First 50 hours
Cleaning water filter(s)
First 50 hours
Replacement and cleaning oil filters and fuel
filters
First 50 uur, every next
250 hours
Cleaning fuel tank
First 50 uur, every next
250 hours
Change the alternator belt
Every 500 hours. yearly.
all following refreshments of pump oil and
reduction gearbox oil.
Cleaning of the heat exchanger (depending
fluid properties and calcium deposits)
Every 250 hours
Refreshing engine oil, maintenance engine
See enclosed motor instruc-
tion manual
Extra control/replacement of joints, valves, o-
rings by acknowledged technicians
Every 750 hours
• lubricate or oil all sliding or jointed parts of
the overrun device
• Check on possible wear of the wheel bra-
kes/ bearings/brake lining.
• Replace the coolant of the engine.
yearly