EN
SERVICE
DiBO 26
STOP SPRAYING ACTIVITIES
Short break
Briefly stop the spraying operations can happen by releasing the lever of the
spray gun. When resuming the spraying activities, press the lever back.
Long break and/or switching off machine
at longer break (> 10 minutes) or when you leave the spray area you need
to switch off the machine completely. proceed as follows: The temperature
regulating knob must be placed in the lowest position at hot water cleaning with
burner. Rince during 1 minute. next, switch off the burner completely.
let the machine run at idle speed and once again rince again for 1 minute with
pure cold water. This to cool down the burner sufficiently. Before switching
off the motor, let it run without any charge for a few minutes (at steady speed,
without spraying) in order to cool down the engine. Then switch off the machine
completely. Close the water supply. operate the lever in the spray gun (release
residual pressure). Remove the keys from the contact.
STORAGE AT FROST TEMPERATURES
add antifreeze to the water in the water supply tank, so the machine can suck
in this liquid. Take the lance from the gun and operate the machine. Spray until
there comes anti-frost out of the gun. The machine is now filled with anti-frost,
stop the machine. antifreeze is an additive which may absolutely not been
drained/discharged without permission. you have to collect the antifreeze water
(which will be sprayed out) in a reservoir. This is also the case when you reuse
the machine again, the antifreeze water which has been left in the machine will
then flow out. always observe the relevant safety instructions of the antifreeze
product.
Tip: the drained antifreeze water can be used again when collected.
Service
GENERAL
all maintenance activities must happen at an disconnected machine and hoses
without pressure. Checking the electric components can happen exclusively by
an expert. Exclusively accessories and replacement components which have
been approved by the manufacturer can be used. Directly after the activities all
securities- and protection parts must be assembled, before the machine is put
into functioning. “a golden rule” that contributes to a perfectly working machine
with few problems, is well the following:
A daily control and cleaning of the machine frequently do wonders!
To be able to guarantee a perfectly working system, one has first necessary a
reliable and technical well considered machine, which is then faced secondly
at regular times with a thorough maintenance. Therefore the experience and
the “know-how” of DiBo a technical good working machine is insured and large
maintenance turns can be carried out by experienced DiBo technicians by
means of appointment or maintenance contract, we can suppose in advance
that it is satisfied to these two points.
MAINTENANCE DIAGRAM
1
General
The user can carry out only those actions for which in this book authorisation
are given. Each other act has been prohibited! For the maintenance turns of
burner kettle, high pressure pump, combustion engines and of components
which have to do with the security, one must contact our DiBo technicians.
open the hood (cap) only for service purposes (example: at engine) using the 2
start buttons (see photo) at the bottom and at the front of the machine.