Osbourne User Manual V0.21
Page 36
9.2 B2B 1G Ethernet Board Connector
A standalone B2B add on RGMII adapter board used to converts the standard ethernet MII signal originated from
module to MDI signals terminated on the standard RJ45 connector mounted on I/O board. Add on board has single
port 1G speed ethernet PHY and other Power Regulator. MDI signals are routed through Osbourne Baseboard 150
pin I/O connector to commercial I/O board.
For Connector and Pin out detail of Refer
9.2.1
Mechanical Drawing
The Mechanical outline of board is depicted below. The board has a form factor of 22 x 24 mm
Figure 4: Mechanical outline of RGMII Board
