Dialogue Flybook A33i, User Manual, Page: 38 / 106

28
Preparing your computer for use
Now that you’ve familiarized yourself with your FlyBook computer, you
can prepare it for use. This section describes how to install the CMOS
battery, DDR SO-DIMM module, and hard disk drive, how to connect
power and start the system, and how to install an operating system.
Installing the CMOS battery and DDR SO-DIMM module
1. Remove the battery if it is on
FlyBook (Refer to “Installing
the battery pack“ for the pro-
cedure.).
2. Press DRAM cover and
stretch out it to open the DDR
SO-DIMM cover on the bot-
tom of your computer.
3. Insert the CMOS battery
(Model# CR1220) into the
battery holder.
4. Insert the DDR SO-DIMM
module into the SO-DIMM
socket as shown, in Figure
12. Make sure it is well inserted.
5. Replace the DDR SO-DIMM cover.
N O T E Do not connect the adapter to supply your computer with power
until you have installed the CMOS battery, DDR SO-DIMM
module, and hard disk drive
.
Figure 12 – Installing DDR
SO-DIMM modules