UM-B-065
Bluetooth® Smart Communication Interface Board
User manual
Revision 1.0
11-May-2016
CFR0012
16 of 24
© 2016 Dialog Semiconductor
Table 8: Wireless Mouse (078-53-D)
Reference design
UART
JTAG
Wireless Mouse
(078-53-D):
1. Connect the target board with the
Tag-Connect cable (
) to
CIB.
2. Power supply:
a. Remove the jumper from the
J16
header.
b. The jumper on
J14
header
must be in place.
c. Connect a battery or an
external power supply (1.5 V
is required), to the target
board turn ON the on-board
switch.
d. Turn ON the power switch
(
SW2
) from CIB.
3. Download the firmware.
4. When the software requests a
reset, please press the reset
button (
SW1
) on the CIB.
1. Connect the target board with the Tag-
Connect cable (
) to CIB.
2. Power supply:
a. Remove the jumper from the
J16
header.
b. The jumper on
J14
header must be in
place.
c. Connect a battery or an external power
supply (1.5 V is required), to the target
board turn ON the on-board switch.
d. Turn ON the power switch (
SW2
) from
CIB.
3. Download the firmware.
Table 9: Remote Control Unit (078-42-C)
Reference design
UART
JTAG
Remote Control
Unit (078-42-C):
Not applicable
1. No specific connectors exist for this design.
User must solder cables to corresponding
test points on the target board.
2. Connect the target board with the modified
connection cable to the CIB.
3. Power supply:
a. Remove the jumper from the
J16
header.
b. The jumper on the
J14
header must be
in place.
c. Connect a battery or an external power
supply to the target board (1.5 V is
required).
d. Turn ON the power switch (
SW2
) from
CIB.
4. Download the firmware.
