UM-B-065
Bluetooth® Smart Communication Interface Board
User manual
Revision 1.0
11-May-2016
CFR0012
15 of 24
© 2016 Dialog Semiconductor
Table 6: Proximity Tag (078-57-B)
Reference design
UART
JTAG
Proximity Tag
(078-57-B):
1. Connect the target board with the
IDC-10 cable (
) to CIB.
2. Power supply:
a. The jumper on
J16
header
must be in place.
b. The jumper on
J14
header
must be in place.
c. In order to supply the target
board from CIB, turn the
power switch (
SW2
) ON.
d. In order to supply the target
board from an external
power supply or battery (3 V
is required), turn the power
switch (
SW2
) OFF.
3. Download the firmware.
4. When the software requests a
reset, press the reset button
SW1
on the CIB.
1. Connect the target board with the IDC-10
cable (
) to CIB.
2. Power supply:
a. The jumper on
J16
header must be in
place.
b. The jumper on
J14
header must be in
place.
c. In order to supply the target board from
CIB, turn the power switch (
SW2
) ON.
d. In order to supply the target board from
an external power supply or battery (3V
is required), turn the power switch
(
SW2
) OFF.
3. Download the firmware.
Table 7: Wireless Keyboard (078-24-B)
Reference design
UART
JTAG
Wireless
Keyboard
(078-24-B):
Not applicable
1. Connect the target board with the Tag-
Connect cable (
) to CIB.
2. Power supply:
a. Remove the jumper from the
J16
header.
b. The jumper on
J14
header must be in
place.
c. Connect a battery or an external power
supply (1.5 V is required).
d. Turn ON the power switch (
SW2
) from
CIB.
3. Download the firmware.
