UM-WI-056
DA16xxx FreeRTOS Getting Started Guide
User Manual
Revision 1.0
27-Oct-2021
CFR0012
14 of 80
© 2021 Dialog Semiconductor
For Linux, the
minicom
terminal emulation program is recommended and can be installed using:
$
$ sudo apt install minicom
Command to install minicom.
$
Once the terminal emulation application has been installed, Connect the USB cable to the EVK (
CN6
on DA16200 EVK or
CN1
on DA16600 EVK) and start the terminal emulation program.
In the terminal emulation program, go to the
Serial Port Setup
and select the lower number COM
port and configure it as follows:
Table 5: Serial Port Configuration Values
Settings
Value
Baud Rate
230400
Data Bits
8
Parity
None
Stop Bits
1
Flow Control (HW/SW)
None
Turn ON the EVK (
SW6
on the DA16200 EVK or
SW2
on the DA16600 EVK) and check for output
similar to the following:
Wakeup source is 0x4
[dpm_init_retmemory] DPM INIT CONFIGURATION(1)
******************************************************
* DA16200 SDK Information
* ---------------------------------------------------
*
* - CPU Type : Cortex-M4 (120MHz)
* - OS Type : FreeRTOS 10.4.3
* - Serial Flash : 4 MB
* - SDK Version : V3.1.3.0 GEN
* - F/W Version : FRTOS-GEN01-01-15129-000000
* - F/W Build Time : Aug 26 2021 22:58:01
* - Boot Index : 0
*
******************************************************
System Mode : Station Only (0)
>>> DA16x Supp Ver2.7 - 2020_07
>>> MAC address (sta0) : d4:3d:39:10:a2:48
>>> sta0 interface add OK
>>> Start STA mode...
[/DA16200] #
Commands can now be entered at the
[/DA16200]
prompt.
A full list of the available debug interface commands can be found in
Configuring the DA14531 Serial Debug Interface (DA16600 EVK only)
This section is for DA16600 only and is required for special cases where access to the DA14531 BLE
devices debug terminal is required.
The DA16600 EVK contains the DA14531 BLE device which is used for provisioning of the DA16600
Wi-Fi interface using a mobile application.
