6
DHOLLANDIA
6
DESCRIPTION AND TERMINOLOGY
6.1
GENERAL
The DH-AI ramps are designed as a multi-purpose solution. They can be used for wheelchair access to assist wheelchair
occupants or persons with an impaired mobility embark and disembark the vehicle. And they can be used as a commercial
ramp, used to load and unload cargo.
Ramps for wheelchair access are usually finished with a mesh aluminum platform surface [option OAP821.0]. A perforated
aluminum plate with non-slip buds is available as an option OAP822.1.
As the ramps come in different versions, it is important to check the capacity of your specific ramp.
DHOLLANDIA lifts and ramps are developed and manufactured using state-of-the-art technology, high quality materials and
components, and highly skilled workmanship. They comply with the European CE / UKCA safety regulations mentioned in the
Declaration of Conformity issued with each lift and ramp (unless otherwise agreed for products exported outside the CE / UKCA
region).
The main types of DH-AI ramps are:
Type
Characteristic
Platform sections
Deployment & storage
Capacity
DH-AI01
Lightweight & portable
1
Fully manual
400 kg
DH-AI02
Lightweight & portable
2
Fully manual
400 kg
DH-AI12
Mounted on vehicle floor
2
Assisted by gas cylinders
400 - 1000 kg
DH-AI13
Mounted on vehicle floor
3
Assisted by gas cylinders
400 kg
In travel position, the ramps type DH-AI12 and DH-AI13 are stowed in upright position, just in front of the vehicle doors (standard
execution), or swung out of the way against the side of the vehicle body [option OAF820.L]. The portable ramps DH-AI01 and
DH-AI02 can be stored anywhere inside or outside the vehicle.
Main details and terminology: see below.
DH-AI01 / 02 / 12 / 13
●
TERMINOLOGY
See figure below for parts corresponding to numbers in this table
#
Description
1
1a
Ramp frame + base plate: steel and aluminum assembly forming the feet of the ramp and connecting the ramp with the
vehicle floor. Following executions are available:
1.
Standard version: ramp frame [1a] + ramp fixations [1b] designed for a fixed position of the ramp inside the vehicle
(no swing facility). The ramp frame [1a] is equipped with quick-release locks [1c] so that the ramp can be dismounted
and mounted very quickly.
2.
Pivoting frame [option OAF820.L]: the ramp frame [1a] incorporates an articulation pin [1d], so that the platform [3]
can be swung inside or outside to clear the door aperture. This ramp is not easily demountable.
1b
Ramp fixations: fixation brackets for the ramp frame [1a] to the vehicle floor. The ramp fixations [1b] remain attached to
the vehicle floor if the ramp is dismounted (in case of standard version).
1c
Quick-release locks:
1.
Standard version: connects and locks the ramp frame [1a] to the ramp fixations [1b].
2.
Pivoting frame [option OAF820.L]: locks the platform [3] + ramp frame [1a] to the base plate in its standard travel
position.
1d
Articulation pin: pin around which the platform [3] + ramp frame [1a] of the pivotable ramp [OAF820.L] can swing inwards
or outwards.
2
Gas cylinders: Gas cylinders make the operation of the ramp light and easy.
3
Platform: carries the load during loading and unloading. Following surfaces are available:
[OAP821.0]
→
Platform in mesh aluminum, evacuating rainwater, snow, dirt, etc. quickly through the platform surface.
